PVC film for the pond. Making a pond

2024 Author: Priscilla Miln | [email protected]. Last modified: 2023-12-16 00:21

Any site, even the most well-maintained and tidy, will look unfinished if it does not have some, at least a small, reservoir. Water acts on any person in a calming and relaxing way, it is pleasant to relax and dream by the pond. If funds and the size of the plot allow, you can make a fairly large pond and put fish into it. It's so nice to sit with a fishing rod after a working day or on a day off, and then enjoy a fresh and fragrant fish soup! As everyone has probably already guessed, the topic of this article will be the construction of a reservoir using PVC film.

PVC film for a pond is, one might say, the golden mean between cheap polyethylene film and expensive butyl rubber, but its quality is much superior to the first and almost as good as the latter. It is not difficult to work with the film, but a certain accuracy is required (the film is still!), Observance of certain rules and sequence of work when constructing a reservoir.

Stages of work on the construction of a reservoir on the site

1. Choice of location. A pond is a closed ecosystem withnatural cleaning. You can install filter pumps, but, again, for large reservoirs, but for now we are talking about a small, cost-effective place to relax. The reservoir should be located in a place protected from the wind and bright sun so that leaves and fallen fruits from trees do not fall into it.
2. The foundation pit. Since we are talking about the device of a reservoir using a PVC film, the pit can be made of any size and shape, manually or mechanically. The size and shape of the future pond depends on the size of the site. On a small plot they make a small pond, preferably of an arbitrary shape. A large plot gives more room for imagination and creativity.

3. 

   Sand lining. The sand should be distributed with a thickness of about 10 cm, this will protect the waterproofing materials from mechanical damage.

4. Laying geotextile. Geotextile is a non-woven material that consists of polypropylene fibers. It is used to ensure tightness, resistant to damage, withstands temperature fluctuations from - 60⁰С to + 100⁰С. It will provide additional protection to the PVC film.
5. Laying waterproofing material. In this case, it is a PVC film for a pond.

To determine the amount of film that will be needed, measure the length and width of the rectangle into which the prepared pit can be entered. The width of the film web will be equal to the width of this rectangle, to which should be added the depth of the pond, multiplied by 2, plus another 1 m. This marginnecessary to firmly secure the ends of the waterproofing on the shore. In the same way, the length of the material is calculated. PVC film for ponds is joined by hot welding or glue.

6. Filling with water and designing the coastal zone of the reservoir. Water should be changed twice a year. At this stage, everyone can feel like a landscape designer and create a recreation area where it will be calm and comfortable. From plants, irises, reeds, hostas, astilba, swimsuit, catchment area and others are suitable.

Acting according to this plan, you can create a very nice pond on the site. It should be noted that the PVC film for the pond is an environmentally friendly material. It tolerates frost well, does not rot and is resistant to damage. In reservoirs arranged in this way, fish live perfectly. If you think that making a pond is expensive and troublesome, then PVC film is your way out. Butyl rubber coatings can be used for the pond, they are more expensive, but with a longer service life (up to 50 years due to their plasticity and strength). They are suitable for creating free-form reservoirs with a relief bottom and steep slopes. If you just want to make a small water oasis, the best solution is PVC film for the pond and your skillful hands.